Nissan Versa

 sedan Owners Manual

Monitor, climate, audio, phone and voice recognition systems » Audio system
iPod* player operation without Navigation System (if so equipped)

Connecting iPod

WARNING

Do not connect, disconnect or operate the USB device while driving. Doing so can be a distraction. If distracted you could lose control of your vehicle and cause an accident or serious injury.

CAUTION

• Do not force the USB device into the USB port. Inserting the USB device tilted or up-side-down into the port may damage the port. Make sure that the USB device is connected correctly into the USB port.
• Do not grab the USB port cover (if so equipped) when pulling the USB device out of the port. This could damage the port and the cover.
• Do not leave the USB cable in a place where it can be pulled unintentionally.

  Pulling the cable may damage the port.

For additional information, refer to your device manufacturer's owner information regarding the proper use and care of the device.

To connect an iPod to the vehicle so that the iPod can be controlled with the audio system controls and display screen, use the USB Connection port located beneath the heater and air conditioner controls. Connect the iPod- specific end of the cable to the iPod and the USB end of the cable to the USB Connection port on the vehicle. If your iPod supports charging via a USB connection, its battery will be charged while connected to the vehicle with the ignition switch in the ACC or ON position.

While connected to the vehicle, the iPod can only be operated by the vehicle audio controls.

To disconnect the iPod from the vehicle, remove the USB end of the cable from the USB Connection port on the vehicle, then remove the cable from the iPod.

* iPod is a trademark of Apple Inc., registered in the U.S. and other countries.

Compatibility

The following models are compatible:

• iPod 5th Generation (firmware version 1.3 or later)
• iPod Classic (80GB) (firmware version 1.1.2PC or later)
• iPod Classic (120GB) (firmware version 2.0.1PC or later)
• iPod nano - 1st generation (firmware version 1.3.1 or later)
• iPod nano - 2nd generation (firmware version 1.1.3 or later)
• iPod nano - 3rd generation (firmware version 1.1.3PC or later)
• iPod nano - 4th generation (firmware version 1.0PC or later)
• iPod nano - 5th generation (8GB) (firmware version 1.0.2PC or later)
• iPod nano - 5th generation (16GB) (firmware version 1.0.1PC or later)
• iPod nano - 6th generation (8GB) (firmware version 1.2PC or later)
• iPod nano - 6th generation (8GB) (firmware version 1.1PC or later)
• iPod Touch - 1st generation (firmware version 2.2.1 or later)
• iPod Touch - 2nd generation (firmware version 2.2.1 or later)
• iPod Touch - 3rd generation (firmware version 3.1.3 or later)
• iPod Touch - 4th generation (firmware version 4.3.5 or later)
• iPhone 3G (firmware version 4.1 or later)
• iPhone 3GS (firmware version 4.3 or later)
• iPhone 4 (firmware version 5.0 or later)
• iPhone 4S (firmware version 5.1 or later)
• iPad (firmware version 4.3.2 or later)
• iPad 2 (firmware version 4.3.3 or later)

Make sure that your iPod firmware is updated to the version indicated above.

Audio main operation

Place the ignition switch to the ACC or ON position. Then, press the iPod MENU button or MEDIA button repeatedly to switch to the iPod mode.

If the audio system is turned off while the iPod is playing, the iPod plays when the audio system is turned back on.

If the audio system is off, pressing the iPod MENU button or MEDIA button turns the audio system on and plays the iPod.

If the audio system is on, the audio system automatically begins playing tracks from the iPod when it is plugged into the connection port.

SEEK/CAT or TRACK buttons

Press the SEEK/CAT or TRACK buttons or to skip backward or forward one track.

Press and hold the SEEK/CAT or TRACK buttons or for 1.5 seconds while a track is playing to reverse or fast forward the track being played. The track plays at an increased speed while reversing or fast forwarding. When the button is released, the track returns to normal play speed.

(RPT) REPEAT

When the RPT button is pressed while a track is being played, the play pattern can be changed as follows: Repeat Off → 1 Track Repeat → All Repeat → Repeat Off

1 Track Repeat: the current track will be repeated.

All Repeat: all songs in the current list are repeated.

Repeat Off: no repeat play pattern is applied.

(RDM) RANDOM

When the RDM button is pressed while a track is being played, the play pattern can be changed as follows: Shuffle Off → Track Shuffle → Album Shuffle → Shuffle Off

Track Shuffle: the tracks in the current list will be played randomly.

Album Shuffle: the albums in the current list will be played randomly.

Shuffle Off: no random play pattern is applied.

BACK button

When the BACK button is pressed, it returns to the previous menu.

Radio

FM radio reception

AM radio reception

Satellite radio reception (if so equipped)

Audio operation precautions

FM/AM radio with compact disc (CD) player (Type A) (if so equipped)

FM/AM radio with compact disc (CD) player (Type B) (if so equipped)

FM/AM/SAT radio with compact disc (CD) player (Type A) (if so equipped)

FM/AM/SAT radio with compact disc (CD) player (Type B) (if so equipped)

USB (Universal Serial Bus) connection port (models without Navigation System) (if so equipped)

USB (Universal Serial Bus) connection port (models with Navigation System) (if so equipped)

iPod* player operation without Navigation System (if so equipped)

iPod* player operation with Navigation System (if so equipped)

Bluetooth streaming audio without Navigation System (Type A) (if so equipped)

Bluetooth streaming audio without Navigation System (Type B) (if so equipped)

Bluetooth streaming audio with Navigation System (if so equipped)

CD care and cleaning

Steering wheel switch for audio control

Antenna