Nissan Versa (N17): Sensor rotor

FRONT SENSOR ROTOR

FRONT SENSOR ROTOR : Removal and Installation

REMOVAL

The front wheel sensor rotor is an integral part of the wheel hub and bearing assembly and can not be replaced individually. When replacing the front wheel sensor rotor replace the hub and bearing assembly.

Refer to FAX "Removal and Installation".

INSTALLATION

Refer to FAX "Removal and Installation".

REAR SENSOR ROTOR

REAR SENSOR ROTOR : Removal and Installation

REMOVAL

Remove the brake drum. Refer to BR "Exploded View".

Remove the sensor rotor from brake drum. Refer to BR "Disassembly and Assembly".

CAUTION: Do not reuse rear sensor rotor.

INSTALLATION

Installation is in the reverse order of removal.

ABS Actuator and electric unit (control unit)

Exploded View 1. ABS actuator and electric unit (control unit) 2. ABS actuator and electric unit (control unit) harness connector 3. Bushing 4. Bracket A. To master cylinder secondary side ...

Other materials:

Additional service when replacing ECM
Description When replacing ECM, the following procedure must be performed. PROGRAMMING OPERATION NOTE: After replacing with a blank ECM, programming is required to write ECM information. Be sure to follow the procedure to perform the programming. Work Procedure 1.CHECK ECM PART NUMBER Che ...

P0607 ECM
DTC Logic DTC DETECTION LOGIC DTC No. Trouble diagnosis (Trouble diagnosis content) DTC detecting condition Possible cause P0607 ECM (CAN communication bus) When detecting error during the initial diagnosis of CAN controller of ECM. ECM DTC CO ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0065