Component Parts Function Inspection
1.CHECK SHIFT POSITION INDICATOR
Is the inspection result normal?
YES >> INSPECTION END
NO >> Go to TM, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT
Is the check result normal?
YES >> INSPECTION END
NO-1 ("RANGE" is changed but is not displayed on shift position indicator.>>Check "Self Diagnostic Result" in "TRANSMISSION".
NO-2 ("RANGE" and shift position indicator are different.)>>Check "Self Diagnostic Result" in "TRANSMISSION".
NO-3 (Specific"RANGE" is not displayed on shift position indicator.)>>Check "Self Diagnostic Result" in "METER/M&A".
OD OFF indicator lampComponent Function Check 1.CHECK OD OFF INDICATOR LAMP FUNCTION Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection results normal? YES &g ...

Component Function Check 1.CHECK SHIFT LOCK OPERATION (BRAKE PEDAL RELEASED) Ignition switch ON. Attempt to shift selector lever to any position other than "P" position with brake pedal rele ...
Additional service when replacing
ECM
Description
When replacing ECM, the following procedure must be performed.
PROGRAMMING OPERATION
NOTE:
After replacing with a blank ECM, programming is required to write ECM
information. Be sure to follow the procedure
to perform the programming.
Work Procedure
1.CHECK ECM PART NUMBER
Che ...
Lock-up control
Lock-up control : system diagram
Lock-up control : system description
The torque converter clutch piston in the torque converter is engaged to
eliminate torque converter slip to
increase power transmission efficiency.
The torque converter clutch control valve operation is controlle ...