Description
The oil pressure warning lamp stays of when the ignition switch is turned ON.
Diagnosis Procedure
1.CHECK COMBINATION METER OIL PRESSURE WARNING LIGHT
1. Select METER/M&A on CONSULT.
2. Observe OIL W/L DATA MONITOR while operating the ignition switch. 
Is the inspection result normal?
YES >> Inspection End.
NO >> Replace combination meter. Refer to MWI "Removal and Installation".
THE OIL PRESSURE WARNING LAMP DOES NOT TURN OFF
Description
The oil pressure warning lamp remains on while the engine is running (normal oil pressure).
Diagnosis Procedure
1.CHECK COMBINATION METER INPUT SIGNAL
1. Start the engine and select METER/M&A on CONSULT.
2. Observe OIL W/L DATA MONITOR and the operation of the oil pressure warning
lamp on the combination
meter. 
Is the inspection result normal?
YES >> Perform ECM self-diagnosis. Refer to EC "CONSULT Function".
NO >> Replace combination meter. Refer to MWI "Removal and Installation".
The fuel gauge indicator does not
operateDescription Fuel gauge will not indicate from a certain position. Diagnosis Procedure 1.CHECK COMBINATION METER INPUT SIGNAL 1. Select METER/M&A on CONSULT. 2. Using "DATA MONITOR, compar ...

Description The warning is still displayed even after washer fluid is added. The warning is not displayed even though the washer tank is empty. Diagnosis Procedure 1.CHECK WASHER FLUID LEV ...
Rear LH
REAR LH : Component Function Check
1.CHECK FUNCTION
Select DOOR LOCK of BCM using CONSULT.
Select DOOR LOCK in ACTIVE TEST mode.
Touch ALL LOCK or ALL UNLK to check that it works normally.
Is the inspection result normal?
YES >> Door lock actuator is OK.
NO >> Refer to DLK ...
Hood lock control cable
HOOD LOCK CONTROL CABLE : Removal and
Installation
REMOVAL
Disconnect hood lock control cable assembly from hood lock assembly.
Refer to DLK "HOOD LOCK
: Removal and Installation".
Remove fender protector (LH). Refer to EXT "Removal and Installation".
Release hoo ...