Nissan Versa (N17): U0155 Lost communication (IPC)

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / U0155 Lost communication (IPC)

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
U0155 Lost Communication With Instrument Panel Cluster (IPC) Control Module When the ignition switch is ON, TCM is unable to receive the CAN communications signal from the combination meter continuously for 2 seconds or more.
  • Combination meter
  • Harness or connector (CAN communication line is open or shorted)

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and wait for at least 5 seconds.
  2. Check the DTC.

Is "U0155" detected?

YES >> Go to TM, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

For the diagnosis procedure, refer to LAN, "Trouble Diagnosis Flow Chart".

U0140 Lost communication (BCM)

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes U0140 Lost Communication With Body Control Module When the ignition ...

U0300 Can communication data

Description The amount of data transmitted from each control unit is read. DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes ...

Other materials:

Child safety
WARNING Do not allow children to play with the seat belts. Most seating positions are equipped with Automatic Locking Retractor (ALR) mode seat belts. If the seat belt becomes wrapped around a child's neck with the ALR mode activated, the child can be seriously injured or killed if the seat ...

Clutch pedal
Inspection and Adjustment 1.   Check to see if the master cylinder rod end moves freely. It should not be bound by the clutch pedal. a. If the rod end does not move freely, remove the rod end and check for deformation or damage on the rod end. Leave the rod end removed ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0075