Nissan Versa (N17): Wiper and washer switch

Nissan Versa 2nd generation (N17) Owners Manual / Instruments and controls / Wiper and washer switch

Switch operation

Type A (if so equipped)
Type A (if so equipped)

The windshield wiper and washer operates when the ignition switch is in the ON position.

Push the lever down to operate the wiper at the following speed:

  1. Intermittent (INT) - intermittent operation can be adjusted by turning the knob toward A (Slower) or B (Faster).
  2. Low (LO)-continuous low speed operation
  3. High (HI) - continuous high speed operation

Type B (if so equipped)
Type B (if so equipped)

Push the lever up 4 to have one sweep operation (MIST) of the wiper.

Pull the lever toward you 5 to operate the washer. The wiper will also operate several times.

WARNING

In freezing temperatures the washer solution may freeze on the windshield and obscure your vision which may lead to an accident. Warm the windshield with the defroster before you wash the windshield.

Type C (if so equipped)
Type C (if so equipped)

CAUTION

  • Do not operate the washer continuously for more than 30 seconds.
  • Do not operate the washer if the reservoir is empty.
  • Do not fill the windshield-washer fluid reservoir with washer fluid concentrates at full strength. Some methyl alcohol based washer fluid concentrates may permanently stain the grille if spilled while filling the windshieldwasher fluid reservoir.
  • Pre-mix windshield-washer fluid concentrates with water to the manufacturer's recommended levels before pouring the fluid into the windshield-washer fluid reservoir. Do not use the windshield-washer fluid reservoir to mix the windshield-washer fluid concentrate and water.

Security systems (if so equipped)

Your vehicle has one type of security systems: NISSAN Vehicle Immobilizer System NISSAN vehicle immobilizer system The NISSAN Vehicle Immobilizer System will not allow the engine to start ...

Rear window defroster switch

To defrost the rear window glass, start the engine and push the rear window defroster switch on. The rear window defroster indicator light on the switch comes on. Push the switch again to tur ...

Other materials:

Fuel level sensor unit
Disassembly and Assembly Fuel Level Sender Unit 1. Harness connectors 2. Level sending unit module 3. Fuel temperature sensor 4. Float arm assembly Disassembly NOTE: Before disassembly, note the proper placement of the wires to the correct terminals and correct wire routing to the term ...

A/T Control system
A/T Control system : component parts location 1. IPDM E/R 2. TCM 3. Transmission range switch 4. A/T unit 5. Output speed sensor 6. Stop lamp switch 7. A/T shift selector 8. Overdrive control switch 9. Combination meter (type B) A/T Control system : component description Name ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.008