Nissan Versa (N17): Accelerator pedal released position learning

Nissan Versa 2nd generation (N17) Service Manual / Engine / Engine control system (EC) / Accelerator pedal released position learning

Description

Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position sensor or ECM is disconnected.

Work Procedure

1.START

  1. Make sure that accelerator pedal is fully released.
  2. Turn ignition switch ON and wait at least 2 seconds.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Turn ignition switch ON and wait at least 2 seconds.
  5. Turn ignition switch OFF and wait at least 10 seconds.

>> END

Additional service when replacing ECM

Description When replacing ECM, the following procedure must be performed. PROGRAMMING OPERATION NOTE: After replacing with a blank ECM, programming is required to write ECM information. Be sur ...

Throttle valve closed position learning

Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It mus ...

Other materials:

General maintenance
During the normal day-to-day operation of the vehicle, general maintenance should be performed regularly as prescribed in this section. If you detect any unusual sounds, vibrations or smells, be sure to check for the cause or have a NISSAN dealer do it promptly. In addition, it is recommended ...

Rear oil seal
REAR OIL SEAL : Removal and Installation REMOVAL Remove transaxle assembly. Remove clutch cover and clutch disk (M/T models). Remove flywheel (M/T models) or drive plate (A/T or CVT models). Remove rear oil seal with a suitable tool. CAUTION: Be careful not to damage crankshaft an ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0046