DTC Logic
| DTC | Trouble diagnosis name | DTC detecting condition | Possible causes |
| U0073 |
Control Module Communication Bus "A" Off |
When the ignition switch is ON, TCM detects a bus-off error continuously for 2 seconds or more. | Harness or connector (CAN communication line is open or shorted) |
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn the ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
Is "U0073" detected?
YES >> Go to TM, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
For the diagnosis procedure, refer to LAN, "Trouble Diagnosis Flow Chart".
Line pressure testWork Procedure INSPECTION Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to LU, "Inspection". Drive for about 10 minutes to warm up the vehicle so ...

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes U0100 Lost Communication With ECM/PCM "A" When the ignition switch ...
P0607 ECM
DTC Logic
DTC DETECTION LOGIC
DTC No.
Trouble diagnosis
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0607
ECM
(CAN communication bus)
When detecting error during the initial diagnosis
of CAN controller of ECM.
ECM
DTC CO ...
P074C Unable to engage 4GR
Description
This malfunction is detected when the A/T does not shift into 4GR position as
instructed by TCM. This is not
only caused by electrical malfunction (circuits open or shorted) but by
mechanical malfunction such as control
valve sticking, improper solenoid valve operation, etc.
DTC ...