Nissan Versa (N17): P0607 ECM

Nissan Versa 2nd generation (N17) Service Manual / Engine / Engine control system (EC) / P0607 ECM

DTC Logic

DTC DETECTION LOGIC

DTC No. Trouble diagnosis (Trouble diagnosis content) DTC detecting condition Possible cause

P0607

 ECM (CAN communication bus) When detecting error during the initial diagnosis of CAN controller of ECM. ECM

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.
  2. Check DTC.

Is DTC detected?

YES >> Proceed to EC, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

  1. Turn ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure. Refer to EC, "DTC Logic".
  4. Check DTC.

Is the DTC P0607 displayed again?

YES >> Replace ECM. Refer to EC, "Removal and Installation".

NO >> INSPECTION END

P0605 ECM

P0643 sensor power supply

Other materials:

Installing front license plate
Use the following steps to mount the front license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag: License plate bracket License plate bracket screws x 2 Screw grommets x 2 1. Hold the license plate bracket 1 and make a ...

U0100 Lost communication (ECM A)
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes U0100 Lost Communication With ECM/PCM "A" When the ignition switch is ON, TCM is unable to receive the CAN communications signal from ECM continuously for 2 ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0068