DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| U0100 | Lost Communication With ECM/PCM "A" | When the ignition switch is ON, TCM is unable to receive the CAN communications signal from ECM continuously for 2 seconds or more. |
|
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn the ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
Is "U0100" detected?
YES >> Go to TM, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
For the diagnosis procedure, refer to LAN, "Trouble Diagnosis Flow Chart".
U0073 Communication bus a offDTC Logic DTC Trouble diagnosis name DTC detecting condition Possible causes U0073 Control Module Communication Bus "A" Off When the ignition switch is ON, ...

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes U0140 Lost Communication With Body Control Module When the ignition ...
When traveling or registering in another country
When planning to drive your NISSAN vehicle
in another country, you should first find
out if the fuel available is suitable for your vehicle's
engine.
Using fuel with an octane rating that is too low
may cause engine damage. All gasoline vehicles
must be operated with unleaded gasoline. There ...
P0982 Shift solenoid D
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0982
Shift Solenoid D Control Circuit
Low
The following diagnosis conditions
are met, and the current
monitor reading of the TCM
high clutch/low & revers ...