Nissan Versa (N17): C1115 ABS Sensor [abnormal signal]

DTC Logic

DTC DETECTION LOGIC       

DTC CONFIRMATION PROCEDURE

1.CHECK SELF DIAGNOSTIC RESULT

With CONSULT.

  1. Start engine and drive vehicle at approximately 30 km/h (19 MPH) or more for approximately 1 minute.
  2. Perform self diagnostic result.

Is DTC C1115 detected?

YES >> Proceed to diagnosis procedure. Refer to BRC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to BRC "Wiring Diagram".

CAUTION: Do not check between wheel sensor terminals.

1.CONNECTOR INSPECTION

  1. Disconnect ABS actuator and electric unit (control unit) connector E33 and wheel sensor connector of wheel with DTC.
  2. Check terminals for deformation, disconnection, looseness or damage.

Is the inspection result normal?

YES >> GO TO 2

NO >> Repair or replace as necessary.

2.CHECK WHEEL SENSOR OUTPUT SIGNAL

  1. Connect ABS active wheel sensor tester (J-45741) to wheel sensor using appropriate adapter.
  2. Turn on the ABS active wheel sensor tester power switch.

    NOTE: The green POWER indicator should illuminate. If the POWER indicator does not illuminate, replace the battery in the ABS active wheel sensor tester before proceeding.

  3. Spin the wheel of the vehicle by hand and observe the red SENSOR indicator on the ABS active wheel sensor tester. The red SENSOR indicator should flash on and off to indicate an output signal.

    NOTE: If the red SENSOR indicator illuminates but does not flash, reverse the polarity of the tester leads and retest.

Does the ABS active wheel sensor tester detect a signal?

YES >> GO TO 3

NO >> Replace the wheel sensor. Refer to BRC "FRONT WHEEL SENSOR : Removal and Installation" (front) or BRC "REAR WHEEL SENSOR : Removal and Installation" (rear).

3.CHECK TIRES

Check the inflation pressure, wear and size of each tire.

Is the inspection result normal?      

YES >> GO TO 4

NO >> Adjust tire pressure, or replace tire(s).

4.CHECK WIRING HARNESS FOR SHORT CIRCUIT

Check continuity between wheel sensor connector terminals and ground of wheel with DTC.   

Is the inspection result normal?

YES >> GO TO 5

NO >> Repair the circuit.

5.CHECK WIRING HARNESS FOR OPEN CIRCUIT

Check continuity between ABS actuator and electric unit (control unit) connector E33 and wheel sensor connector of wheel with DTC.       

Is the inspection result normal?

YES >> Replace the ABS actuator and electric unit (control unit). Refer to BRC-108, "Removal and Installation".

NO >> Repair the circuit.

Other materials:

Interior lights
The interior light has a three-position switch and operates regardless of ignition switch position. When the switch is in the ON position 1 , the interior lights illuminate, regardless of door position. The lights will go off after a period of time unless the ignition switch is placed i ...

Event Data Recorders (EDR)
This vehicle is equipped with an Event Data Recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road obstacle, data that will assist in understanding how a vehicle's systems performed. The EDR is de ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0068