Nissan Versa (N17): Coil spring

Nissan Versa 2nd generation (N17) Service Manual / Suspension / Rear suspension (RSU) / Coil spring

Exploded View

Exploded View

1. Upper rubber seat 2. Coil spring 3. Lower rubber seat 4. Rear suspension beam

Removal and Installation

REMOVAL

  1. Remove the wheel and tire assemblies using power tool. Refer to WT "Adjustment".
  2. Position a suitable jack under rear suspension beam.

CAUTION:

  • Place the jack in the center of the suspension beam.
  • Do not damage the suspension beam with jack.
  1. Remove the lower shock absorber bolts. Refer to RSU "Removal and Installation".
  2. Slowly lower jack, then remove upper rubber seat, coil spring and lower rubber seat from rear suspension beam.

INSTALLATION

Installation is in the reverse order of removal.

  • Install the lower rubber seat (A) to the rear suspension beam mounting hole (B).
  • Match up lower rubber seat indentions and rear suspension beam grooves and attach.

INSTALLATION

Inspection

INSPECTION AFTER REMOVAL

Check rubber seat and coil spring for deformation, crack, and damage. Replace it if necessary.

INSPECTION AFTER INSTALLATION

Check wheel alignment. Refer to RSU "Inspection".

Rear shock absorber

Exploded View 1. Piston rod lock nut 2. Washer 3. Bushing 4. Distance tube 5. Bound bumper cover 6. Bound bumper 7. Shock absorber assembly 8. Rear suspension beam ...

Rear suspension beam

Exploded View 1. Rear suspension beam Removal and Installation REMOVAL Remove the wheel and tire assemblies using power tool. Refer to WT "Adjustment". Remove wheel sensor ...

Other materials:

Front drive shaft
Exploded View 1. Drive shaft 2. Cotter pin A. Apply Molykote M77 Removal and Installation REMOVAL Remove the wheel and tire assembly using power tool. Refer to WT "Adjustment". Remove wheel sensor and sensor harness. Refer to BRC "FRONT WHEEL SENSOR : Removal and ...

Front grille
Exploded View 1. Front grille 2. Front emblem Pawl Removal and Installation REMOVAL 1. Remove front bumper fascia. Refer to EXT "Removal and Installation". 2. Remove front grille nuts (A). 3. Pull front grille out away from vehicle to disengage pawls and then remove front gr ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0069