Nissan Versa (N17): P0890 TCM

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / P0890 TCM

DTC Logic

DTC DETECTION LOGIC

DTC

Trouble diagnosis name

DTC detection condition

Possible causes

P0890

Transmission control module power relay sense circuit low

The battery voltage supplied to the TCM is less than 8.4 V continuously for 200 msec or more under the following diagnosis condition:

- Diagnosis condition

- TCM power supply voltage: More than 11 V

Harness or connector (TCM power supply (back-up) circuit is open or shorted.)

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

Start the engine and wait for 5 seconds or more.
Check the DTC.

Is "P0890" detected?

YES >> Go to TM "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK TCM POWER SUPPLY (BACK-UP) CIRCUIT

Turn ignition switch OFF.
Disconnect TCM connector.
Check voltage between TCM harness connector terminals and ground.

Is the inspection result normal?

YES >> Check intermittent incident. Refer to GI "Intermittent Incident".

NO >> GO TO 2.

2.DETECT MALFUNCTIONING ITEMS

Check the following items:

Open or short circuit of harness between battery positive terminal and TCM connectors terminals 45 and 46.
10A fuse (No.25, fuse and fusible link block). Refer to PG "Terminal Arrangement".

Is the inspection result normal?

YES >> Check intermittent incident. Refer to GI "Intermittent Incident".

NO >> Repair or replace malfunctioning parts.

P0863 TCM Communication

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0863 TCM Communication Circui An error is detected at the initial CA ...

P0962 Pressure control solenoid A

Other materials:

Automatic speed control device (ASCD)
Automatic speed control device (ascd) : switch name and function SWITCHES AND INDICATORS 1. CRUISE indicator 2. CANCEL switch 3. ACCEL/RES switch 4. COAST/SET switch 5. ASCD MAIN switch A. On the combination meter B. On the steering wheel SET SPEED RANGE ASCD system can be set the follow ...