Nissan Versa (N17): P0962 Pressure control solenoid A

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / P0962 Pressure control solenoid A

DTC Logic

DTC DETECTION LOGIC

DTC

Trouble diagnosis name

DTC detection condition

Possible causes

P0962

Pressure Control Solenoid A Control Circuit Low

The line pressure solenoid valve current is 200 mA or less continuously for 200 msec or more under the following diagnosis conditions:

- Diagnosis conditions

- Solenoid output current: 750 mA or more

- GND short diagnosis of the solenoid drive circuit is satisfied.

- TCM power supply voltage: More than 11 V

- Harness or connector (Line pressure solenoid valve circuit is shorted to ground)

- Line pressure solenoid valve

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

Start the engine and wait for 5 seconds or more.
Check the first trip DTC.

Is "P0962" detected?

YES >> Go to TM "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT

Turn ignition switch OFF.
Disconnect TCM connector and CVT unit connector.
Check continuity between TCM harness connector terminal and ground.

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace malfunctioning parts.

2.CHECK LINE PRESSURE SOLENOID VALVE

Check line pressure solenoid valve. Refer to TM, "Component Inspection (Line Pressure Solenoid Valve)".

Is the inspection result normal?

YES >> Check intermittent incident. Refer to GI "Intermittent Incident".

NO >> Repair or replace malfunctioning parts.

Component Inspection (Line Pressure Solenoid Valve)

1.CHECK LINE PRESSURE SOLENOID VALVE

Check resistance between CVT unit connector terminal and ground.

Is the inspection result normal?

YES >> INSPECTION END

NO >> There is a malfunction of line pressure solenoid valve. Replace transaxle assembly. Refer to TM "Removal and Installation".

P0890 TCM

P0963 Pressure control solenoid A

Other materials:

P0705 Transmission range switch A
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0705 Transmission Range Sensor "A" Circuit Malfunction (PRNDL input) The following diagnosis conditions are met and 2 or more position signals are ON at the ...

Passenger air bag module
Exploded View 1. Passenger air bag module 2. Instrument panel assembly Pawl Removal and Installation WARNING: Before servicing, turn ignition switch OFF, disconnect both the battery negative and positive terminals, then wait at least three minutes. Always work from the side of ai ...

Nissan Versa (N17): P0962 Pressure control solenoid A

DTC Logic

Diagnosis Procedure

P0890 TCM

P0963 Pressure control solenoid A

Other materials:

Categories