Toyota
Nissan Versa
 Sedan Service Manual
Engine » Engine control system (EC) » P0137 HO2s2
Diagnosis Procedure

1.HECK GROUND CONNECTION

  1. Turn ignition switch OFF.
  2. Check ground connection E15. Refer to Ground Inspection in GI, "Circuit Inspection".

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace ground connection.

2.CLEAR THE MIXTURE RATIO SELFLEARNING VALUE

  1. Clear the mixture ratio selflearning value. Refer to EC, "Work Procedure".
  2. Run engine for at least 10 minutes at idle speed.

Is the 1st trip DTC P0171 detected? Is it difficult to start engine?

YES >> Perform trouble diagnosis for DTC P0171. Refer to EC, "DTC Logic".

NO >> GO TO 3.

3.CHECK HO2S2 GROUND CIRCUIT FOR OPEN AND SHORT

  1. Turn ignition switch OFF.
  2. Disconnect heated oxygen sensor 2 harness connector.
  3. Disconnect ECM harness connector.
  4. Check the continuity between HO2S2 harness connector and ECM harness connector.

CHECK HO2S2 GROUND CIRCUIT FOR OPEN AND SHORT

    5.   Also check harness for short to ground and short to power.

Is the inspection result normal?

YES >> GO TO 4.

NO >> Repair open circuit, short to ground or short to power in harness or connectors.

4.CHECK HO2S2 INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT

    1.   Check the continuity between HO2S2 harness connector and ECM harness connector.

CHECK HO2S2 INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT

    2.   Check the continuity between HO2S2 harness connector ground or ECM harness connector and ground.

CHECK HO2S2 INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT

CHECK HO2S2 INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT

    3.   Also check harness for short to power.

Is the inspection result normal?

YES >> GO TO 5.

NO >> Repair open circuit, short to ground or short to power in harness or connectors.

5.CHECK HEATED OXYGEN SENSOR 2

Refer to EC, "Component Inspection".

Is the inspection result normal?

YES >> GO TO 7.

NO >> GO TO 6.

6.REPLACE HEATED OXYGEN SENSOR 2

Replace malfunctioning heated oxygen sensor 2. Refer to EX, "Exploded View"

CAUTION:

  • Discard any heated oxygen sensor which has been dropped from a height of more than 0.5 m (19.7 in) onto a hard surface such as a concrete floor; use a new one.
  • Before installing new oxygen sensor, clean exhaust system threads using Oxygen Sensor Thread Cleaner [commercial service tool (J4389718 or J4389712)] and approved antiseize lubricant (commercial service tool).

>> INSPECTION END

7.CHECK INTERMITTENT INCIDENT

Refer to GI, "Intermittent Incident".

>> INSPECTION END

    More about «P0137 HO2s2»:

    DTC Logic

    Component Function Check

    Diagnosis Procedure

    Component Inspection

    Nissan Versa Sedan Service Manual / Engine / Engine control system (EC) / P0137 HO2s2 / Diagnosis Procedure

    Nissan Versa Sedan Service Manual

    Categories


    © 2017-2024 Copyright www.niveguide.com