Nissan Versa (N17): P0603 ECM power supply

Nissan Versa 2nd generation (N17) Service Manual / Engine / Engine control system (EC) / P0603 ECM power supply

Description

ECM has the memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the Idle Air Volume Learning value memory, etc. even when the ignition switch is turned OFF.

Power supply

DTC Logic

DTC DETECTION LOGIC

DTC No. Trouble diagnosis DTC detecting condition Possible cause

P0603

 ECM BACK UP/CIRCUIT (ECM power supply circuit) ECM back-up RAM system does not function properly.
  • Harness or connectors [ECM power supply (back up) circuit is open or shorted.]
  • ECM

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON wait at least 10 seconds.
  2. Turn ignition switch OFF and wait at least 5 minutes
  3. Turn ignition switch ON, wait at least 10 seconds.
  4. Repeat step 2 and 3 for five times.
  5. Check 1st trip DTC.

Is 1st trip DTC detected?

YES >> Go to EC, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

  1. Erase DTC.
  2. Perform DTC CONFIRMATION PROCEDURE.

Is the 1st trip DTC P0603 displayed again?

YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

  1. Replace ECM. Refer to EC, "Removal and Installation".
  2. Perform EC, "Work Procedure".

>> INSPECTION END

P0524 engine oil pressure

P0605 ECM

Other materials:

Power steering
WARNING If the engine is not running or is turned off while driving, the power assist for the steering will not work. Steering will be harder to operate. When the power steering warning light illuminates with the engine running, there will be no power assist for the steering. You w ...

EVAP canister filter
Exploded View 1. EVAP canister vent control valve hose 2. Canister drain hose 3. EVAP canister filter Front Removal and Installation REMOVAL Remove the EVAP canister protector cover. Disconnect EVAP canister vent control valve hose from EVAP canister filter. Disconnect caniste ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0067