Nissan Versa (N17): Differential side oil seal

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / Differential side oil seal

Exploded View

Exploded View

1. Transaxle assembly 2. Differential side oil seal (left side) 3. Differential side oil seal (right side) Front Genuine NISSAN Matic S ATF

Removal and Installation

NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

REMOVAL

  1. Remove the front drive shafts from the transaxle assembly. Refer to FAX "Removal and Installation".
  2. Remove the differential side oil seal using suitable tool.

CAUTION: When removing the differential side oil seal, be careful not to scratch the oil seal mating surfaces of the transaxle case and converter housing.

INSTALLATION

1. Drive the differential side oil seal into the transaxle case side (A) and converter housing side (B) using suitable tool to the specified dimension.

CAUTION:

  • Be careful not to scratch the lip of the differential side oil seal when press-fitting it.
  • Do not reuse differential side oil seal.
  • Apply Genuine NISSAN Matic S ATF to the differential side oil seal lip and around the oil seal.

Dimension (C) : 1.8 +- 0.5 mm (0.071 +- 0.020 in).

Dimension (D) : 1.8 +- 0.5 mm (0.071 +- 0.020 in).

Removal and Installation

2. Install the front drive shaft. Refer to FAX "Removal and Installation".

Inspection and Adjustment

INSPECTION AFTER INSTALLATION

Check for A/T fluid leakage. Refer to TM "Inspection".

ADJUSTMENT AFTER INSTALLATION

Check the A/T fluid level. Refer to TM "Adjustment".

Output speed sensor

Exploded View 1. Output speed sensor 2. O-ring 3. Transaxle assembly Front Removal and Installation REMOVAL Remove the front LH wheel and tire. Disconnect the harness connector from o ...

Fluid cooler tube

Exploded View 1. Fluid cooler tube A 2. Copper sealing washer 3. Fluid cooler tube B 4. Bolt 5. Transaxle assembly Removal and Installation WARNING: Do not open the radiator cap or drain p ...

Other materials:

Sun visors
1. To block glare from the front, swing down the sun visor 1 . 2. To block glare from the side, remove the sun visor from the center mount and swing the visor to the side 2 . 3. Slide the extension 3 sun visor in or out as needed. CAUTION Do not store the sun visor before returning ...

P1715 Input speed sensor
Description ECM receives input speed sensor signal from TCM via the CAN communication line. ECM uses this signal for engine control. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. If DTC P1715 is displa ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0062