Nissan Versa (N17): Door lock

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Door lock

DOOR LOCK : Removal and Installation

REMOVAL

1. Remove inside handle. Refer to DLK "INSIDE HANDLE : Removal and Installation".

2. Remove outside handle. Refer to DLK "OUTSIDE HANDLE : Removal and Installation".

3. Remove bolt (A) from the front door glass channel rear (1).

REMOVAL

4. Disconnect the harness connector from door lock actuator.

5. Remove door lock assembly bolts and door lock assembly.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Do not reuse door lock assembly bolt. Always replace it with a new one when it is removed.
After installation, check door open/close, lock/unlock operation.
Check door lock cable is properly engaged with outside handle bracket.
Check door lock assembly for poor lubrication. Apply a suitable multi-purpose grease to door lock if necessary.

REMOVAL

Outside handle

OUTSIDE HANDLE : Removal and Installation REMOVAL 1. Fully close the front door glass. 2. Remove front door finisher. Refer to INT "Removal and Installation". 3. Remove sealing screen. ...

Inside handle

INSIDE HANDLE : Removal and Installation REMOVAL 1. Remove rear door finisher. Refer to INT "Removal and Installation". 2. Remove upper side of sealing screen. NOTE: Cut the butyl tape ...

Other materials:

Interior lights
The interior light has a three-position switch and operates regardless of ignition switch position. When the switch is in the ON position 1 , the interior lights illuminate, regardless of door position. The lights will go off after a period of time unless the ignition switch is placed i ...

Specifications
Engine This spark ignition system complies with the Canadian standard ICES-002. Wheels and tires Dimensions and weights ...

Nissan Versa (N17): Door lock

Outside handle

Inside handle

Other materials:

Categories