Nissan Versa (N17): Door lock

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Door lock

DOOR LOCK : Removal and Installation

REMOVAL

Remove inside handle. Refer to DLK "INSIDE HANDLE : Removal and Installation".
Remove outside handle. Refer to DLK "OUTSIDE HANDLE : Removal and Installation".
Disconnect the harness connector from door lock actuator (if equipped).
Remove front door lower sash (rear). Refer to GW "Exploded View".
Remove door lock assembly bolts and door lock assembly.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Do not reuse door lock assembly bolt. Always replace it with a new one when it is removed.
After installation, check door open/close, lock/unlock operation.
Check door lock cable is properly engaged with outside handle bracket.
Check door lock assembly for poor lubrication. Apply a suitable multi-purpose grease to door lock if necessary.

INSTALLATION

Inside handle

INSIDE HANDLE : Removal and Installation REMOVAL 1. Remove front door finisher. Refer to INT "Removal and Installation". 2. Remove upper side of sealing screen. NOTE: Cut the butyl ta ...

Other materials:

U1000 Can comm circuit
Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability. Many electronic control units are equipped onto a vehicle, and ...

Air breather hose
Removal and Installation REMOVAL Remove air duct (inlet). Refer to EM "Exploded View". Remove air breather hose from transaxle assembly. INSTALLATION Installation is in the reverse order of removal. CAUTION: Check that air breather hose is not collapsed or blocked due to ...

Nissan Versa (N17): Door lock

Hood lock bell crank

Inside handle

Other materials:

Categories