Nissan Versa (N17): Inside handle

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Inside handle

INSIDE HANDLE : Removal and Installation

REMOVAL

1. Remove front door finisher. Refer to INT "Removal and Installation".

2. Remove upper side of sealing screen.

NOTE: Cut the butyl tape so that some parts of the butyl tape remain on the sealing screen, if the sealing screen is reused.

3. Release lock knob cable (2) and inside handle cable (3) from clip (1).

REMOVAL

4. Remove inside handle bolt.

5. Release inside handle (1) from door panel (2) by sliding toward vehicle rear and separating.

: Pawl

: Front

REMOVAL

6. Disengage inside handle cable (3) and lock knob cable (2), and remove inside handle (1).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: After installation, check door open/close, lock/unlock operation.

Door lock

DOOR LOCK : Removal and Installation REMOVAL Remove inside handle. Refer to DLK "INSIDE HANDLE : Removal and Installation". Remove outside handle. Refer to DLK "OUTSIDE HANDLE ...

Outside handle

OUTSIDE HANDLE : Removal and Installation REMOVAL 1. Fully close the front door glass. 2. Remove front door finisher. Refer to INT "Removal and Installation". 3. Remove sealing screen. ...

Other materials:

Oil pump
Exploded View 1. Rear oil seal 2. Oring 3. Oil pan (upper) 4. Oil pump chain tensioner (for oil pump drive chain) 5. Oil pump drive chain 6. Crankshaft key 7. Crankshaft sprocket 8. Oil pump sprocket 9. Oil pump 10. Oring 11. Oring 12. Oil pan drain plug 13. Drain plug washer 14. Oil pan ( ...

Power supply and ground circuit
Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS "Wiring Diagram". 1.CHECK FUSES AND FUSIBLE LINK Check that the following fuses and fusible link are not blown. Is the fuse blown? YES >> Replace the blown fuse or fusible link after repairing the affected ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0055