Diagnosis Procedure
1.CHECK DOOR LOCK FUNCTION
Check door lock function.
Does door lock/unlock using door request switch?
YES >> GO TO 2.
NO >> Refer to DLK "Diagnosis Procedure".
2.CHECK INTELLIGENT KEY WARNING BUZZER
Check Intelligent Key warning buzzer.
Refer to DLK "Component Function Check".
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace the malfunctioning parts.
3.REPLACE BCM
Is the result normal?
YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI "Intermittent Incident".
Intelligent key low battery warning
does not operateDiagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM Is the inspection result normal? YES >> GO TO 2. NO >> Perform trouble diagnosis relevant to DTC indic ...

Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM Is the inspection result normal? YES >> GO TO 2. NO >> Perform trouble diagnosis relevant to DTC ind ...
Electric ignition system
ELECTRIC IGNITION SYSTEM : System Diagram
ELECTRIC IGNITION SYSTEM : System Description
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Engine speed*3
Piston position
Ignition timing control
Igni ...
U1000 Can COMM circuit
Description
CAN (Controller Area Network) is a serial communication line for real-time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent malfunction
detection ability.
Many electronic control units are equipped onto a vehicle, an ...