Nissan Versa (N17): C1143 Steering angle sensor

DTC Logic

DTC DETECTION LOGIC       

DTC CONFIRMATION PROCEDURE

1.CHECK SELF DIAGNOSTIC RESULT

With CONSULT.

  1. Turn ignition switch ON.
  2. Perform self diagnostic result.

Is DTC C1143 detected?

YES >> Proceed to diagnosis procedure. Refer to BRC"Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to BRC-45, "Wiring Diagram".

1.CONNECTOR INSPECTION

  1. Turn ignition switch OFF.
  2. Disconnect ABS actuator and electric unit (control unit) and steering angle sensor connectors.
  3. Check connectors and terminals for deformation, disconnection, looseness or damage.

Is the inspection result normal?

YES >> GO TO 2

NO >> Repair or replace as necessary.

2.CHECK STEERING ANGLE SENSOR MOUNTING CONDITION

Check steering angle sensor mounting condition.

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace malfunctioning components.

3.CHECK STEERING ANGLE SENSOR POWER SUPPLY

  1. Turn ignition switch OFF.
  2. Disconnect steering angle sensor connector.
  3. Turn ignition switch ON.
  4. Check voltage between steering angle sensor connector M64 terminal 4 and ground.

Is the inspection result normal?

YES >> GO TO 5.

NO >> GO TO 4.

4.CHECK STEERING ANGLE SENSOR POWER SUPPLY CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect IPDM E/R connector E45.
  3. Check continuity between steering angle sensor connector M64 terminal 4 and IPDM E/R connector E45 terminal 20.           

    4.   Check continuity between steering angle sensor connector M64 terminal 4 and ground. 

Is the inspection result normal?

YES >> Perform trouble diagnosis for ignition power supply. Refer to PG "Wiring Diagram - Ignition Power Supply -".

NO >> Repair or replace malfunctioning components.

5.CHECK STEERING ANGLE SENSOR GROUND CIRCUIT

  1. Turn ignition switch OFF.
  2. Check continuity between steering angle sensor connector M64 terminal 1 and ground.

Is the inspection result normal?

YES >> GO TO 6.

NO >> Repair or replace malfunctioning components.

6.CHECK CAN COMMUNICATION LINE

Check "STRG BRANCH LINE CIRCUIT". Refer to BRC "Diagnosis Procedure" (type 1) or BRC"Diagnosis Procedure" (type 2).

Is the inspection result normal?

YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC "Removal and Installation".

NO >> Repair or replace malfunctioning components.

Other materials:

B terminal circuit
Description Terminal "B" is constantly supplied with battery power. Diagnosis Procedure Regarding Wiring Diagram information, refer to STR, "Wiring Diagram - With Intelligent Key System" or STR, "Wiring Diagram - Without Intelligent Key System". CAUTION: Perform diagnosis ...

Trunk lid finisher
Exploded View 1. Trunk lid finisher 2. Emblem 3. Rear view camera (if equipped) Pawl Clip Removal and Installation REMOVAL 1. Remove trunk lid finisher inner. Refer to INT "Removal and Installation". 2. Remove trunk lid finisher nuts. 3. Disconnect the harness connectors from ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0067