Toyota
Nissan Versa
 Sedan Service Manual
Engine » Engine control system (EC) » Engine control system
EVAP Canister Vent Control Valve

The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent.

This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized.

A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system components.

This solenoid valve is used only for diagnosis, and usually remains opened.

When the vent is closed, under normal purge conditions, the evaporative emission control system is depressurized and allows "EVAP Control System" diagnosis.

EVAP Canister Vent Control Valve

EVAP Control System Pressure Sensor

The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases.

EVAP Control System Pressure Sensor

    More about «Engine control system»:

    Accelerator Pedal Position Sensor

    Air Fuel Ratio Sensor 1

    Air Fuel Ratio Sensor 1 Heater

    Battery Current Sensor

    Camshaft Position Sensor

    Crankshaft Position Sensor

    Engine Oil Temperature Sensor

    EVAP Canister Vent Control Valve

    Exhaust Valve Timing Control Solenoid Valve

    Fuel Injector

    Fuel Pump

    Heated Oxygen Sensor 2

    Intake Air Temperature Sensor

    Intake Valve Timing Control Solenoid Valve

    Malfunction Indicator Lamp (MIL)

    Mass Air Flow Sensor

    Oil Pressure Warning Lamp

    Throttle Position Sensor

    Nissan Versa Sedan Service Manual / Engine / Engine control system (EC) / Engine control system / EVAP Canister Vent Control Valve

    Nissan Versa Sedan Service Manual

    Categories


    © 2017-2024 Copyright www.niveguide.com