Nissan Versa (N17): OD OFF indicator lamp

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / OD OFF indicator lamp

Component Function Check

1.CHECK OD OFF INDICATOR LAMP FUNCTION

Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON.

Is the inspection results normal?

YES >> INSPECTION END

NO >> Go to TM "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC (TCM)

With CONSULT

  1. Turn ignition switch ON.
  2. Check "Self Diagnostic Results" in "TRANSMISSION".

Is any DTC detected?

YES >> Check DTC detected item. Refer to TM "DTC Index".

NO >> GO TO 2.

2.CHECK DTC (COMBINATION METER)

With CONSULT

Check "Self Diagnostic Results" in "METER/M&A".

Is any DTC detected?

YES >> Check DTC detected item. Refer to MWI "DTC Index".

NO >> GO TO 3.

3.CHECK COMBINATION METER INPUT SIGNAL

With CONSULT

  1. Shift the selector lever to "D" position.
  2. Select "Data Monitor" in "METER/M&A".
  3. Select "O/D OFF IND".
  4. Check that "O/D OFF IND" turns ON/OFF when overdrive control switch is operated. Refer to MWI "Reference Value".

Is the inspection result normal?

YES >> Replace combination meter. Refer to MWI "Removal and Installation".

NO >> GO TO 4.

4.CHECK TCM INPUT/OUTPUT SIGNAL

With CONSULT

  1. Select "Data Monitor" in "TRANSMISSION".
  2. Select "SPORT MODE SW".
  3. Check that "SPORT MODE SW" turns ON/OFF when overdrive control switch is operated. Refer to TM "Reference Value".

Is the inspection result normal?

YES >> Replace combination meter. Refer to MWI "Removal and Installation".

NO >> Check overdrive control switch. Refer to TM "Diagnosis Procedure".

Overdrive control switch

Shift position indicator circuit

Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR Start the engine. Shift selector lever. Check that the selector lever position and the shift position indicator on the ...

Other materials:

Before starting the engine
Make sure the area around the vehicle is clear. Check fluid levels such as engine oil, coolant, brake and clutch fluid (if so equipped), and windshield-washer fluid as frequently as possible, or at least whenever you refuel. Check that all windows and lights are clean. Visually insp ...

Accelerator control system
Exploded View 1. Accelerator pedal assembly 2. Brake pedal bracket A. Locating hook B. Locating pin Removal and Installation CAUTION: Do not disassemble accelerator pedal assembly. Do not remove accelerator pedal position sensor from accelerator pedal assembly. Avoid impact from ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0066