Nissan Versa (N17): Shift position indicator circuit

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / Shift position indicator circuit

Component Parts Function Inspection

1.CHECK SHIFT POSITION INDICATOR

  1. Start the engine.
  2. Shift selector lever.
  3. Check that the selector lever position and the shift position indicator on the combination meter are identical.

Is the inspection result normal?

YES >> INSPECTION END

NO >> Go to TM, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK TCM INPUT/OUTPUT SIGNAL

With CONSULT

  1. Start the engine.
  2. Select "Data Monitor" in "TRANSMISSION".
  3. Select "RANGE".
  4. Shift selector lever.
  5. Check that selector lever position, "RANGE" on CONSULT screen, and shift position indicator display on combination meter are identical.

Is the check result normal?

YES >> INSPECTION END

NO-1 ("RANGE" is changed but is not displayed on shift position indicator.>>Check "Self Diagnostic Result" in "TRANSMISSION".

NO-2 ("RANGE" and shift position indicator are different.)>>Check "Self Diagnostic Result" in "TRANSMISSION".

NO-3 (Specific"RANGE" is not displayed on shift position indicator.)>>Check "Self Diagnostic Result" in "METER/M&A".

OD OFF indicator lamp

Component Function Check 1.CHECK OD OFF INDICATOR LAMP FUNCTION Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection results normal? YES &g ...

Shift lock system

Component Function Check 1.CHECK SHIFT LOCK OPERATION (BRAKE PEDAL RELEASED) Ignition switch ON. Attempt to shift selector lever to any position other than "P" position with brake pedal rele ...

Other materials:

Continuously Variable Transmission (CVT) fluid (if so equipped)
CAUTION NISSAN recommends using Genuine NISSAN CVT Fluid NS-3 (or equivalent) ONLY in NISSAN CVTs. Do not mix with other fluids. Do not use Automatic transmission fluid (ATF) or Manual transmission fluid in a NISSAN CVT, as it may damage the CVT. Damage caused by the use of fluids ...

Drive belt
1. Water pump pulley 2. Generator pulley 3. Manual tensioner pulley 4. Air conditioner compressor pulley 5. Crankshaft pulley WARNING Be sure the ignition switch is placed in the OFF or LOCK position before servicing drive belt. The engine could rotate unexpectedly. 1. Visually inspect t ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0054