Nissan Versa (N17): Hood hinge

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Hood hinge

HOOD HINGE : Removal and Installation

REMOVAL

  1. Remove hood assembly. Refer to DLK "HOOD ASSEMBLY : Removal and Installation".
  2. Remove hood support rod and grommet. Refer to DLK"HOOD SUPPORT ROD : Removal and Installation".
  3. Remove front fender. Refer to DLK "FRONT FENDER : Removal and Installation".
  4. Remove hood hinge bolts and remove hood hinge.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Check hood hinge rotating point for poor lubrication. If necessary, apply a suitable multi-purpose grease.
  • Perform hood fitting adjustment procedure. Refer to DLK "HOOD ASSEMBLY : Adjustment".
  • After adjusting, apply touch-up paint (body color) onto the head of hood hinge bolts and nuts.

INSTALLATION

HOOD SUPPORT ROD

HOOD SUPPORT ROD : Removal and Installation

REMOVAL

  1. Support hood assembly using a suitable tool.

    WARNING: Bodily injury may occur if hood assembly is not supported properly when removing hood support rod.

  2. Rotate and remove hood support rod from grommet.
  3. Release tab and remove grommet from hood hinge, if necessary.

INSTALLATION

Installation is in the reverse order of removal.

RADIATOR CORE SUPPORT

Exploded View

Exploded View

1. Radiator upper seal 2. Condenser side seal 3. Radiator side seal (RH) 4. Radiator side seal (LH) 5. Radiator core support lower 6. Radiator core support upper

Hood assembly

Radiator core support upper

RADIATOR CORE SUPPORT UPPER : Removal and Installation RADIATOR CORE SUPPORT UPPER Removal 1. Remove ground harness bolt (A). 2. Remove horn. Refer to HRN "Removal and Installation" ...

Other materials:

Hood
1. Pull the hood lock release handle 1 located below the instrument panel until the hood springs up slightly. 2. Locate the lever 2 in between the hood and grille and push the lever sideways with your fingertips. 3. Raise the hood 3 . 4. Remove the support rod and insert it into the ...

Parking brake system
Inspection and Adjustment INSPECTION When parking brake lever is operated with a force of 196 N (20 kg-f, 44 lb-f), make sure parking brake lever stroke is within the specified number of notches. (Check it by listening and counting ratchet clicks.) Number of notches : Refer to PB "Park ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0083