Nissan Versa (N17): Radiator core support upper

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Radiator core support upper

RADIATOR CORE SUPPORT UPPER : Removal and Installation

RADIATOR CORE SUPPORT UPPER

Removal

1. Remove ground harness bolt (A).

Removal

2. Remove horn. Refer to HRN "Removal and Installation".

3. Remove hood lock assembly and hood lock control cable assembly clip. Refer to DLK "HOOD LOCK : Removal and Installation".

4. Remove crash zone sensor. Refer to SR "Removal and Installation".

5. Remove radiator cap adapter bracket bolt (A) and radiator reservoir tank bolt (B).

Removal

6. Remove radiator upper seal clips.

7. Remove upper clips of radiator side seal (LH/RH).

8. Disconnect all harness clips.

9. Remove front bumper fascia upper side clips (A).

Removal

10. Remove radiator core support upper bolts.

11. Pull back on upper part of front bumper fascia (1) and then remove radiator core support upper (2) by pulling upward.

Removal

Installation

Installation is in the reverse order of removal.

Hood hinge

HOOD HINGE : Removal and Installation REMOVAL Remove hood assembly. Refer to DLK "HOOD ASSEMBLY : Removal and Installation". Remove hood support rod and grommet. Refer to DLK" ...

Radiator core support lower

RADIATOR CORE SUPPORT LOWER : Removal and Installation Removal 1. Remove under cover. Refer to EXT "Removal and Installation". 2. Remove radiator upper seal clips. 3. Remove front bumpe ...

Other materials:

Starting the engine (models without NISSAN Intelligent Key system)
1. Apply the parking brake. 2. Automatic Transmission / CVT models: Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The shift lever cannot be moved out of P (Park) and into any of the other gear positions if the ignition key is turned to the OFF position or if ...

Valve oil seal
VALVE OIL SEAL : Removal and Installation REMOVAL Remove camshafts. Remove valve lifters. Rotate crankshaft, and set piston with valve oil seal to be removed to TDC. This will prevent the valve from dropping into cylinder. CAUTION: When rotating crankshaft, be careful to avoid ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.007