Nissan Versa (N17): Hood lock

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Hood lock

HOOD LOCK : Removal and Installation

REMOVAL

1. Remove hood lock assembly bolts and hood lock assembly.

2. Disconnect hood lock control cable assembly (2) from hood lock assembly (1).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Be careful not to bend the cable too much, keep the radius 100 mm (3.94 in) or more.
  • Check that hood lock control cable is properly engaged with hood lock.
  • After installation, perform hood adjustment procedure. Refer to DLK "HOOD ASSEMBLY : Adjustment".
  • After adjusting, perform hood lock control inspection. Refer to DLK "Inspection".

Trunk lid weather-strip

TRUNK LID WEATHER-STRIP : Removal and Installation REMOVAL Remove trunk lid weatherstrip from the trunk lid opening. CAUTION: Do not pull excessively on weatherstrip. INSTALLATION 1. Working fro ...

Hood lock control cable

HOOD LOCK CONTROL CABLE : Removal and Installation REMOVAL Disconnect hood lock control cable assembly from hood lock assembly. Refer to DLK "HOOD LOCK : Removal and Installation&quo ...

Other materials:

Battery
Keep the battery surface clean and dry. Clean the battery with a solution of baking soda and water. Make certain the terminal connections are clean and securely tightened. If the vehicle is not to be used for 30 days or longer, disconnect the negative (-) battery terminal cable to ...

Line pressure test
Work Procedure INSPECTION Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to LU, "Inspection". Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is to 50 to 80C (122 to 176F). Inspect the amount of ATF. Rep ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0081