Nissan Versa (N17): Trunk lid weather-strip

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Trunk lid weather-strip

TRUNK LID WEATHER-STRIP : Removal and Installation

REMOVAL

Remove trunk lid weatherstrip from the trunk lid opening.

CAUTION: Do not pull excessively on weatherstrip.

INSTALLATION

1. Working from the upper section, align weatherstrip center mark (A) with vehicle center mark (B) and install weatherstrip onto the vehicle.

REMOVAL

2. Align the connecting point (B) of weatherstrip (2) to the center (A) of striker (1) and install as shown.

REMOVAL

3. Make sure entire weatherstrip is firmly seated.

NOTE: Check that weatherstrip fits tightly all around the opening, especially in each corner and along the luggage rear plate.

HOOD LOCK

Exploded View

Exploded View

1. Secondary latch 2. Hood lock assembly 3. Hood lock control cable assembly Clip

Torsion bar

TORSION BAR : Removal and Installation REMOVAL 1. Remove torsion bar clamp. 2. Support trunk lid with a suitable tool. WARNING: Bodily injury may occur if trunk lid is not supported properly wh ...

Hood lock

HOOD LOCK : Removal and Installation REMOVAL 1. Remove hood lock assembly bolts and hood lock assembly. 2. Disconnect hood lock control cable assembly (2) from hood lock assembly (1). INSTALLAT ...

Other materials:

Power steering
WARNING If the engine is not running or is turned off while driving, the power assist for the steering will not work. Steering will be harder to operate. When the power steering warning light illuminates with the engine running, there will be no power assist for the steering. You w ...

Component parts
Component Parts Location 1. Condenser 2. Compressor 3. Refrigerant pressure sensor 4. Liquid tank 5. Evaporator 6. Expansion valve A. Built-in heater & cooling unit assembly Component Description Component Description Evaporator The mist form liquid refrigerant t ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0085