Nissan Versa (N17): Inside handle

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Inside handle

INSIDE HANDLE : Removal and Installation

REMOVAL

1. Remove front door finisher. Refer to INT "Removal and Installation".

2. Remove upper side of sealing screen.

NOTE: Cut the butyl tape so that some parts of the butyl tape remain on the sealing screen, if the sealing screen is reused.

3. Disengage lock knob cable (2) and inside handle cable (3) from clip (1).

REMOVAL

4. Remove inside handle bolt.

5. Disengage inside handle (1) from door panel (2) by sliding toward vehicle rear and separating.

: Pawl

: Front

REMOVAL

6. Disengage inside handle cable (3) and lock knob cable (2), and remove inside handle (1).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: After installation, check door open/close, lock/unlock operation.

Door lock

DOOR LOCK : Removal and Installation REMOVAL Remove inside handle. Refer to DLK "INSIDE HANDLE : Removal and Installation". Remove outside handle. Refer to DLK "OUTSIDE HANDLE ...

Outside handle

OUTSIDE HANDLE : Removal and Installation REMOVAL 1. Fully close the front door glass. 2. Remove front door finisher. Refer to INT "Removal and Installation". 3. Remove sealing screen. ...

Other materials:

EVAP canister vent control valve
Exploded View 1. EVAP canister 2. O-ring 3. EVAP canister vent control valve 4. EVAP canister vent control valve hose Removal and Installation NOTE: The EVAP canister vent control valve can be removed without removing the EVAP canister. REMOVAL Remove the EVAP canister protector cov ...

Shift lock system
SHIFT LOCK SYSTEM : Component Parts Location 1. Stop lamp switch 2. Shift lock release lever 3. Park position switch 4. Shift lock solenoid Component Function Stop lamp switch Stop lamp switch turns ON when brake pedal is depressed Shift lock release lever Ma ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0085