Nissan Versa (N17): Low tire pressure warning lamp

Nissan Versa 2nd generation (N17) Service Manual / Suspension / Road wheels & tires (WT) / Low tire pressure warning lamp

Component Function Check

1.CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP

Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON.

Is the inspection result normal?

YES >> Inspection End.

NO >> Perform trouble diagnosis. Refer to WT "Diagnosis Procedure".

Diagnosis Procedure

1.PERFORM SELF DIAGNOSTIC RESULT

With CONSULT

  1. Turn the ignition switch ON.
  2. Perform "SELF DIAGNOSTIC RESULT".

Are any DTCs detected?

YES >> Refer to BCS "DTC Index" or BCS "DTC Index".

NO >> GO TO 3.

2.CHECK LOW TIRE PRESSURE WARNING LAMP SIGNAL

With CONSULT

  1. Turn the ignition switch ON.
  2. On "DATA MONITOR" select "WARNING LAMP."
  3. Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON.

Is the inspection result normal?

YES >> Check the combination meter. Refer to MWI, "CONSULT Function" (type B) or MWI "CONSULT Function" (type A).

NO >> Replace the BCM. Refer to BCS "Removal and Installation" or BCS "Removal and Installation".

Other materials:

Security systems (if so equipped)
Your vehicle has one type of security systems: NISSAN Vehicle Immobilizer System NISSAN vehicle immobilizer system The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key. If the engine fails to start using a registered key (for ex ...

Output speed sensor
Exploded View 1. Transaxle assembly 2. Output speed sensor 3. O-ring Front Genuine NISSAN CVT Fluid NS-3 Removal and Installation REMOVAL Disconnect the harness connector from output speed sensor. NOTE: Lift up the vehicle and perform the work from rear of the transaxle asse ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0073