Nissan Versa (N17): Malfunction indicator lamp

Component Function Check

1.CHECK MIL FUNCTION

  1. Turn ignition switch ON.
  2. Make sure that MIL lights up.

Is the inspection result normal?

YES >> INSPECTION END

NO >> Go to EC, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC UXXXX is not displayed.

Is DTC detected?

YES >> Perform trouble diagnosis for DTC UXXXX.

NO >> GO TO 2.

2.CHECK COMBINATION METER

Check DTC with combination meter. Refer to MWI, "DTC Index" (TYPE A) or MWI, "DTC Index" (TYPE B).

Is DTC detected?

YES >> Perform troubleshooting relevant to DTC indicated.

NO >> GO TO 3.

3.CHECK INTERMITTENT INCIDENT

Refer to GI, "Intermittent Incident".

Is the inspection result normal?

YES >> Replace combination meter. Refer to MWI, "Removal and Installation" (TYPE A) or MWI, "Removal and Installation" (TYPE B). Check the vehicle type to confirm the service information in MWI section. Refer to MWI, "Information".

NO >> Repair or replace harness or connectors.

On board refueling vapor recovery (ORVR)

Component Function Check 1.CHECK ORVR FUNCTION Check whether the following symptoms are present. Fuel odor from EVAP canister is strong. Cannot refuel/Fuel odor from the fuel filler opening i ...

Other materials:

Accelerator pedal released position learning
Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position senso ...

P072F Stuck in 4GR
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P072F Stuck in Gear 4 The following diagnosis conditions are met and the detection conditions continue for 0.5 seconds or more.- Diagnosis condition - Shifti ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0063