Description
TCM compares the calculated value stored in the flash ROM with the value stored in TCM. If the calculated value does not agree with the stored value, TCM judges this as a malfunction.
DTC Logic
DTC DETECTION LOGIC
DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
P062F |
Internal Control Module EEPROM Error | Flash ROM error is detected when turning ON the ignition switch. |
|
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
Is "P062F" detected?
YES >> Go to TM "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK INTERMITTENT INCIDNT
Refer to GI "Intermittent Incident".
Is the inspection result normal?
YES >> Replace the TCM. Refer to TM "Removal and Installation".
NO >> Repair or replace malfunctioning parts.
Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...
Jump starting
To start your engine with a booster battery, the
instructions and precautions below must be followed.
WARNING
If done incorrectly, jump starting can
lead to a battery explosion, resulting in
severe injury or death. It could also
damage your vehicle.
Explosive hydrogen gas is always pre ...
TCM
Exploded View
1. TCM 2. Bracket 3. Clips
Front
Removal and Installation
NOTE:
When replacing the TCM and transaxle assembly as a set, replace the transaxle
assembly first and then
replace the TCM. Refer to TM, "Description".
REMOVAL
Remove the battery. Refer to PG &q ...