Nissan Versa (N17): P072E Stuck in 3GR

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
P072E Stuck in Gear 3 The following diagnosis conditions are met and the detection conditions continue for 0.5 seconds or more.

- Diagnosis condition

- Shifting is not in progress.

- Stop lamp switch OFF

- Detection conditions

- Deceleration: Less than - 0.35 G

- Gear ratio: 6% or more, or − 6% or less compared with normal gear ratio

- 2-4 brake solenoid valve

- Control valve assembly

DTC REPRODUCTION PROCEDURE

CAUTION:

  • "TM, "Diagnosis Procedure"" must be performed before starting "DTC CONFIRMATION PROCEDURE".
  • Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
  • Always drive vehicle at a safe speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1. Start the engine.
  2. Drive the vehicle.
  3. Maintain the following conditions for 5 seconds or more.
  4. Check the first trip DTC.

Selector lever : D position (O/D OFF)

Gear : 3GR

Stop lamp switch : OFF

Vehicle speed : 20 km/h (13 MPH) or more

Is "P072E" detected?

YES >> Go to TM, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.MALFUNCTION CAUSE SIMULATION TEST

Refer to GI, "Intermittent Incident".

Is the check result normal?

YES >> Replace the transaxle assembly. Refer to TM, "Removal and Installation".

NO >> Repair or replace the malfunctioning parts.

P072D Stuck in 2GR

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P072D Stuck in Gear 2 The following diagnosis conditions are met an ...

P072F Stuck in 4GR

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P072F Stuck in Gear 4 The following diagnosis conditions are met a ...

Other materials:

Rear window defroster switch
To defrost the rear window glass, start the engine and push the rear window defroster switch on. The rear window defroster indicator light on the switch comes on. Push the switch again to turn the defroster off. The rear window defroster automatically turns off after approximately 15 m ...

Break-in schedule
CAUTION During the first 1,200 miles (2,000 km), follow these recommendations to obtain maximum engine performance and ensure the future reliability and economy of your new vehicle. Failure to follow these recommendations may result in shortened engine life and reduced engine performance. ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.007