DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| P072D | Stuck in Gear 2 | The following diagnosis conditions
are met and the detection
conditions continue for 0.5 seconds
or more. - Diagnosis condition - Shifting is not in progress. - Stop lamp switch OFF - Detection conditions - Deceleration: Less than - 0.35 G - Gear ratio: 6% or more, or − 6% or less compared with normal gear ratio |
|
DTC REPRODUCTION PROCEDURE
CAUTION:
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
Selector lever : 2 position
Gear : 2GR
Stop lamp switch : OFF
Vehicle speed : 20 km/h (13 MPH) or more
Is "P072D" detected?
YES >> Go to TM, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.MALFUNCTION CAUSE SIMULATION TEST
Refer to GI, "Intermittent Incident".
Is the check result normal?
YES >> Replace the transaxle assembly. Refer to TM, "Removal and Installation".
NO >> Repair or replace the malfunctioning parts.
P072C Stuck in 1GRDTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P072C Stuck in Gear 1 The following diagnosis conditions are met a ...

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P072E Stuck in Gear 3 The following diagnosis conditions are met a ...
Continuously Variable Transmission (CVT) fluid (if so equipped)
CAUTION
NISSAN recommends using Genuine
NISSAN CVT Fluid NS-3 (or equivalent)
ONLY in NISSAN CVTs. Do not mix with
other fluids.
Do not use Automatic transmission
fluid (ATF) or Manual transmission fluid
in a NISSAN CVT, as it may damage the
CVT. Damage caused by the use of fluids
...
Battery
Keep the battery surface clean and dry.
Clean the battery with a solution of baking
soda and water.
Make certain the terminal connections are
clean and securely tightened.
If the vehicle is not to be used for 30 days or
longer, disconnect the negative (-) battery
terminal cable to ...