BACK-UP LAMP SWITCH : Component Inspection
1.CHECK BACK-UP LAMP SWITCH

Is the inspection result normal?
YES >> INSPECTION END
NO >> Replace position switch. Refer to TM, "Removal and Installation".

PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection
1.CHECK PARK/NEUTRAL POSITION (PNP) SWITCH

Is the inspection result normal?
YES >> INSPECTION END
NO >> Replace position switch. Refer to TM, "Removal and Installation".

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, repair or replace these parts.

Structure and operationSectional View 1. Clutch housing 2. 1st-2nd synchronizer hub assembly 3. 3rd-4th synchronizer hub assembly 4. 5th input gear 5. 5th-reverse synchronizer hub assembly 6. 5th-reverse baulk ri ...

Inspection OIL LEAKAGE Make sure that gear oil is not leaking from transaxle or around it. OIL LEVEL Remove filler plug (1) and gasket from transaxle case. Check the oil level from filler pl ...
Power steering fluid
Check the fluid level in the reservoir.
The fluid level should be checked when the fluid
is cold at fluid temperatures of 32 to 86ºF (0 to
30ºC). The fluid level can be checked with the
level gauge which is attached to the cap. To
check the fluid level, remove the cap. The fluid ...
Intake manifold
Exploded View
1. EVAP canister purge volume control
solenoid valve
2. Hose clamp 3. Vacuum hose
4. PCV hose 5. Hose clamp 6. Intake manifold support
7. Gasket 8. Intake manifold 9. Electric throttle control actuator
10. Gasket 11. EVAP service port
A. To air duct B. To centralized underf ...