REAR OIL SEAL : Removal and Installation
REMOVAL
CAUTION:
Be careful not to damage crankshaft and cylinder block.
INSTALLATION
1. Apply the liquid gasket lightly to entire outside area of new rear oil seal.
Use Genuine Silicone RTV Sealant or equivalent.
2. Install rear oil seal so that each seal lip is oriented as shown.
(A) : Dust seal lip
(B) : Oil seal lip
: Engine outside
: Engine inside

CAUTION:

(A) : Rear end surface of cylinder block
(b) : 0 0.5 mm (0 0.020 in)

3. Installation of the remaining components is in the reverse order of removal.
Front oil sealFRONT OIL SEAL : Removal and Installation REMOVAL 1. Remove the following parts. Remove wheel and tire. Front fender protector (RH). Drive belt ...
U0101 can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an onvehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped onto a vehicle, and each con ...
Line pressure control
Line pressure control : system diagram
Line pressure control : system description
When an engine and A/T integrated control signal (engine torque)
equivalent to the engine drive force is
transmitted from the ECM to the TCM, the TCM controls the line pressure
solenoid valve.
Th ...