Nissan Versa (N17): Service data and specifications (SDS)

Nissan Versa 2nd generation (N17) Service Manual / Engine / Engine control system (EC) / Service data and specifications (SDS)

Idle Speed   

*: Under the following conditions

  • A/C switch: OFF
  • Electric load: OFF (Lights, heater fan & rear window defogger)
  • Steering wheel: Kept in straight-ahead position

Ignition Timing  

*: Under the following conditions

  • A/C switch: OFF
  • Electric load: OFF (Lights, heater fan & rear window defogger)
  • Steering wheel: Kept in straight-ahead position

Calculated Load Value       

Mass Air Flow Sensor       

*: Engine is warmed up to normal operating temperature and running under no load.

Removal and installation

ECM Exploded View 1. ECM bracket 2. ECM  : Vehicle front Removal and Installation CAUTION: Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refer to EC-122, "Work Procedure". ...

Precautions

Other materials:

Steering wheel
Tilt operation Push the lock lever 1 down and adjust the steering wheel up or down 2 to the desired position. Pull the lock lever 1 up to lock the steering wheel in place. WARNING Do not adjust the steering wheel while driving. You could lose control of your vehicle and cause an accid ...

U1000 CAN Comm
Description Refer to LAN "CAN COMMUNICATION SYSTEM : System Description". DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0081