Nissan Versa (N17): Side air bag module

Removal and Installation

REMOVAL

WARNING: Do not leave any objects (screwdrivers, tools, etc.) on the seat during seatback repair. It can lead to personal injury if the side air bag should accidentally deploy.

CAUTION:

  • Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
  • Handle the side air bag module carefully. During disassembly, always hold the side air bag module, do not let it hang by the wire harness.
  • Always place the side air bag module with the deployment side facing upward.
  • Always work from the side or back of the seatback assembly, do not work in front of seat.
  • Do not use air tools or electric tools for servicing the seat assembly.
  • Replace the side air bag module if it has been dropped or sustained an impact.
  • Do not insert any objects into the side air bag module.
  • Do not attempt to disassemble the air bag module.
  • Do not expose the side air bag module to temperatures exceeding 90C (194F).
  • Do not expose the side air bag module to any oil, grease, detergent or water.
  • During disassembly, do not damage the seatback cover, chutes, connectors, retainers, clips, module harness or the side air bag module.

NOTE:

  • If the vehicle has been involved in a collision and the side air bag has deployed, the front seatback assembly must be replaced.
  • For side air bag module removal and installation, seatback trim and seatback pad must be released from the seatback frame for access.
  1. Remove the driver or passenger seat assembly. Refer to SE "DRIVER SIDE : Removal and Installation".
  2. Disassemble the seatback, release the seatback trim and seatback pad as an assembly, then remove side air bag module from the seatback. Refer to SE "DRIVER SIDE : Disassembly and Assembly" (DRIVER SIDE) or SE "PASSENGER SIDE : Disassembly and Assembly" (PASSENGER SIDE).

NOTE: The side air bag module is removed from the seat frame, then through the sewn in chute, as part of the seatback cover and pad disassembly procedure.

INSTALLATION

Installation is in the reverse order of removal.

Side curtain air bag module

Exploded View 1. Side curtain air bag module 2. Side curtain air bag module connector A. Adhesive tape area Removal and Installation REMOVAL CAUTION: Before servicing, turn ignition sw ...

Crash zone sensor

Exploded View 1. Crash zone sensor 2. Bracket A. Nut Front Removal and Installation REMOVAL WARNING: Before servicing, turn ignition switch OFF, disconnect battery negative terminal ...

Other materials:

Hazard warning flasher switch
Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights flash. WARNING If stopping for an emergency, be sure to move the vehicle well off the road. Do not use the hazard warning flashers while moving on the highway unl ...

Shift control
SHIFT CONTROL : System Description SYSTEM DIAGRAM DESCRIPTION To select the gear ratio that can give the driving force to meet driver's intent or vehicle situation, the vehicle driving condition such as vehicle speed or accelerator pedal position is detected and the most appropriate g ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0065