Nissan Versa (N17): Torsion bar

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Torsion bar

TORSION BAR : Removal and Installation

REMOVAL

Remove torsion bar clamp.
Support trunk lid with a suitable tool.

WARNING: Bodily injury may occur if trunk lid is not supported properly when removing the torsion bars.

REMOVAL

3. Apply a torsion bar wrench (A) to torsion bar (1) and lift torsion bar to remove it.

NOTE: For torsion bar wrench, refer to the figure.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: Check trunk lid open/close operation after installation.

Trunk lid hinge

TRUNK LID HINGE : Removal and Installation REMOVAL 1. Remove harness clips (A) from trunk lid hinge (RH only) (1). 2. Remove trunk lid assembly. Refer to DLK "TRUNK LID ASSEMBLY : Removal ...

Trunk lid weather-strip

TRUNK LID WEATHER-STRIP : Removal and Installation REMOVAL Remove trunk lid weatherstrip from the trunk lid opening. CAUTION: Do not pull excessively on weatherstrip. INSTALLATION 1. Working fro ...

Other materials:

Power steering
WARNING If the engine is not running or is turned off while driving, the power assist for the steering will not work. Steering will be harder to operate. When the power steering warning light illuminates with the engine running, there will be no power assist for the steering. You w ...

Jump starting
To start your engine with a booster battery, the instructions and precautions below must be followed. WARNING If done incorrectly, jump starting can lead to a battery explosion, resulting in severe injury or death. It could also damage your vehicle. Explosive hydrogen gas is always pre ...

Nissan Versa (N17): Torsion bar

Trunk lid hinge

Trunk lid weather-strip

Other materials:

Categories