TRUNK LID WEATHER-STRIP : Removal and Installation
REMOVAL
Remove trunk lid weatherstrip from the trunk lid opening.
CAUTION: Do not pull excessively on weatherstrip.
INSTALLATION
1. Working from the upper section, align weatherstrip center mark (A) with vehicle center mark (B) and install weatherstrip onto the vehicle.
: Front
2. Align the connecting point (B) of weatherstrip (2) to the center (A) of striker (1) and install as shown.
3. Make sure entire weatherstrip is firmly seated.
NOTE: Check that weatherstrip fits tightly all around the opening, especially in each corner and along the luggage rear plate.
HOOD LOCK
Exploded View
1. Secondary latch 2. Hood lock assembly 3. Hood lock control cable assembly
Clip
TORSION BAR : Removal and Installation REMOVAL Remove torsion bar clamp. Support trunk lid with a suitable tool. WARNING: Bodily injury may occur if trunk lid is not supported properly when ...
HOOD LOCK : Removal and Installation REMOVAL Remove hood lock assembly bolts and hood lock assembly. Disconnect hood lock control cable assembly (2) from hood lock assembly (1). INSTALLA ...
P0720 Output speed sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0720
Output Speed Sensor Circuit
Under the following diagnosis
conditions, the output speed
sensor value is less than 100
rpm continuously for 5 seconds
or ...
P0731 1GR Incorrect ratio
Description
This malfunction is detected when the A/T does not shift into 1GR position as
instructed by TCM. This is not
only caused by electrical malfunction (circuits open or shorted) but by
mechanical malfunction such as control
valve sticking, improper solenoid valve operation, etc.
DTC ...