Nissan Versa (N17): A-BAG Branch line circuit

Nissan Versa 2nd generation (N17) Service Manual / Electrical & power control / LAN System (LAN) / A-BAG Branch line circuit

Diagnosis Procedure

WARNING: Always observe the following items for preventing accidental activation.

  • Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.)
  • Never use unspecified tester or other measuring device.

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the air bag diagnosis sensor unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

YES >> GO TO 2.

NO >> Replace the main harness.

2.CHECK AIR BAG DIAGNOSIS SENSOR UNIT

Check the air bag diagnosis sensor unit. Refer to SRC"Work Flow".

Is the inspection result normal?

YES >> Replace the main harness.

NO >> Replace parts whose air bag system has a malfunction.

TCM Branch line circuit 

Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, ben ...

DLC Branch line circuit 

Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the data link connector ...

Other materials:

Fluid cooler tube
Exploded View 1. Fluid cooler tube A 2. Copper sealing washer 3. Fluid cooler tube B 4. Bolt 5. Transaxle assembly Removal and Installation WARNING: Do not open the radiator cap or drain plug when the engine is hot. There is a danger that hot liquid may spray out, causing serious in ...

Calibration of G Sensor
Description TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed. Removal/installation or replacement of G sensor Replacement of TCM Work ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.007