Nissan Versa (N17): Inspection and adjustment

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Inspection and adjustment

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM)

Additional service when replacing control unit (bcm) : Description

EFORE REPLACEMENT

When replacing BCM, save or print current vehicle specification with CONSULT configuration before replacement.

NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

AFTER REPLACEMENT

CAUTION:

  • When replacing BCM, you must perform "After Replace ECU" with CONSULT.
  • Complete the procedure of "After Replace ECU" in order.
  • If you set incorrect "After Replace ECU", incidents might occur.
  • Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
  • When replacing BCM, perform the system initialization (NATS).

Additional service when replacing control unit (BCM) : Work Procedure

1.SAVING VEHICLE SPECIFICATION

CONSULT

Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

>> GO TO 2.

2.REPLACE BCM

Replace BCM. Refer to BCS "Removal and Installation".

>> GO TO 3.

3.WRITING VEHICLE SPECIFICATION

CONSULT

  1. Enter "Re/Programming, Configuration".
  2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to DLK "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Procedure".
  3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to DLK "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Procedure".

>> GO TO 4.

4.INITIALIZE BCM (NATS)

Perform BCM initialization. (NATS)

>> Work End.

DTC/CIRCUIT DIAGNOSIS

Diagnosis and repair work flow

Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incide ...

Other materials:

Starting the engine (models without NISSAN Intelligent Key system)
1. Apply the parking brake. 2. Automatic Transmission / CVT models: Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The shift lever cannot be moved out of P (Park) and into any of the other gear positions if the ignition key is turned to the OFF position or if ...

Vehicle identification
Vehicle identification number (VIN) plate The vehicle identification number (VIN) plate is attached as shown. This number is the identification for your vehicle and is used in the vehicle registration. Vehicle identification number (chassis number) The vehicle identification number i ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0092