ROOM LAMP
WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.
CAUTION: Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
REMOVAL
1. Remove lens (1) and remove the room lamp by pulling down to release the room lamp metal clips (A).
2. Disconnect the harness connector from the room lamp and remove.
INSTALLATION Installation is in the reverse order of removal.
ROOM LAMP
WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.
CAUTION:
Removal
1. Remove lens (1) by inserting suitable tool and releasing LH (switch side first).
2. Remove bulb (2).
Installation
Installation is in the reverse order of removal.
NOTE: Insert the lens hook end RH side first to install lens.
Exploded View 1. Map lamp bulb housing 2. Bulb 3. Lens Pawl ...
Air cleaner filter
Exploded View
1. Clamp 2. PCV hose 3. Clamp
4. Mount rubber 5. Air duct (inlet) 6. Air cleaner body
7. Grommet 8. Air cleaner filter 9. Air cleaner cover
10. Mass air flow sensor 11. Air duct 12. Clamp
Removal and Installation
REMOVAL
1. Unhook clips (A) and pull the air cleaner cover u ...
P0974 Shift solenoid A
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0974
Shift Solenoid "A" Control Circuit
High
The following diagnosis conditions
are met, and the TCM select
switch ON-OFF solenoid
valve monitor value is OF ...