Nissan Versa (N17): Front wiper auto stop signal circuit

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Wiper & washer (WW) / Front wiper auto stop signal circuit

Component Function Check

1. CHECK FRONT WIPER (AUTO STOP) SIGNAL

1. Select FR WIPER STOP of BCM (WIPER) data monitor item.

2. Operate the front wiper.

3. Check that FR WIPER STOP changes from ON to OFF according to the wiper position.

Is the inspection result normal?

YES >> Front wiper auto stop signal circuit is normal.

NO >> Refer to WW "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to WW "Wiring Diagram".

1. CHECK FRONT WIPER MOTOR (AUTO STOP) OUTPUT VOLTAGE

1. Turn the ignition switch ON.

2. Check voltage between IPDM E/R harness connector and ground.

Is the inspection result normal?

YES >> Check for intermittent failure.

NO >> GO TO 2

2. CHECK FRONT WIPER MOTOR (AUTO STOP) SHORT CIRCUIT

1. Turn the ignition switch OFF.

2. Disconnect IPDM E/R and front wiper motor.

3. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal?

YES >> Repair or replace harness.

NO >> GO TO 3.

3. CHECK FRONT WIPER MOTOR (AUTO STOP) CIRCUIT CONTINUITY

Check continuity between IPDM E/R harness connector and front wiper motor harness connector.

Is the inspection result normal?

YES >> Replace front wiper motor. Refer to WW "WIPER DRIVE ASSEMBLY : Removal and Installation".

NO >> Repair or replace harness.

Front wiper motor ground circuit

Diagnosis Procedure Regarding Wiring Diagram information, refer to WW "Wiring Diagram". 1. CHECK FRONT WIPER MOTOR GROUND CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect front wip ...

Other materials:

P0706 Transmission range sensor A
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0706 Transmission Range Sensor "A" Circuit Range/Performance The following diagnosis conditions are met and the position signal is OFF continuously for 15 ...

Door check link
DOOR CHECK LINK : Removal and Installation REMOVAL Fully close the front door window. Remove front door finisher. Refer to INT "Removal and Installation". Remove front door speaker bolts. Disconnect harness connector from front door speaker and remove. Remove door check link ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0063