Nissan Versa (N17): B2622 Inside antenna

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / B2622 Inside antenna

DTC Logic

DTC DETECTION LOGIC 

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Select INTELLIGENT KEY of BCM using CONSULT.
  2. Select INSIDE ANT DIAGNOSIS in WORK SUPPORT mode.
  3. Perform inside key antenna (INSIDE ANT DIAGNOSIS) on WORK SUPPORT of INTELLIGENT KEY.
  4. Check BCM for DTC.

Is inside key antenna DTC detected?

YES >> Refer to DLK "Diagnosis Procedure".

NO >> Inside key antenna (console) is OK.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to DLK "INTELLIGENT KEY SYSTEM : Wiring Diagram".

1.CHECK INSIDE KEY ANTENNA INPUT SIGNAL 1

  1. Turn ignition switch ON.
  2. Check signal between BCM harness connector and ground using oscilloscope.

Is the inspection result normal?

YES >> Replace BCM. Refer to BCS "Removal and Installation".

NO >> GO TO 2.

2.CHECK INSIDE KEY ANTENNA CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect BCM connector and inside key antenna (console) connector.
  3. Check continuity between BCM harness connector and inside key antenna (console) harness connector
  4. Check continuity between BCM harness connector and ground. 

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace harness.

3.CHECK INSIDE KEY ANTENNA INPUT SIGNAL 2

  1. Replace inside key antenna (console). (New antenna or other antenna)
  2. Connect BCM connector and inside key antenna (console) connector.
  3. Turn ignition switch ON.
  4. Check signal between BCM harness connector and ground using oscilloscope. 

Is the inspection result normal?

YES >> Replace inside key antenna (console).

NO >> Replace BCM. Refer to BCS "Removal and Installation".

Other materials:

Exhaust system
Exploded View 1. Heated oxygen sensor 2 2. Catalyst cover (upper) 3. Seal bearing 4. Catalyst cover (lower) 5. Spring 6. Spring 7. Mounting rubber 8. Main muffler 9. Ring gasket 10. Center muffler 11. Mounting rubber 12. Seal bearing 13. Exhaust front tube Removal and Installation WARNIN ...

Insufficient heating
Description Symptom Insufficient heating No warm air comes out. (Air flow volume is normal.) Diagnosis Procedure NOTE: Perform self-diagnosis with CONSULT before performing symptom diagnosis. If any malfunction result or DTC is detected, perform the corresponding diagnosis. 1.CHECK ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0072