Nissan Versa (N17): Vehicle security indicator

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / Vehicle security indicator

Description

  • Vehicle security indicator is built in combination meter.
  • NATS (Nissan Anti-Theft System) condition is indicated by blink or illumination of vehicle security indicator.

Component Function Check

1.CHECK FUNCTION

1. Perform Active Test of THEFT IND in the IMMU mode with CONSULT.

2. Check vehicle security indicator operation.

Is the inspection result normal?

YES >> Inspection End.

NO >> Refer to SEC "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to SEC "Wiring Diagram".

1.SECURITY INDICATOR LAMP ACTIVE TEST

With CONSULT

Check "THEFT IND" in "ACTIVE TEST" of IMMU mode with CONSULT.

Without CONSULT

1. Disconnect BCM.

2. Check voltage between BCM harness connector M18 terminal 23 and ground.

Is the inspection result normal?

YES >> Security indicator lamp is OK.

NO >> GO TO 2

2.SECURITY INDICATOR LAMP CHECK

Check security indicator lamp condition.

Is the inspection result normal?

YES >> GO TO 3

NO >> Replace combination meter. Refer to MWI "Removal and Installation" (type B) or MWI "Removal and Installation" (type A).

3.CHECK HARNESS CONTINUITY

1. Turn ignition switch OFF.

2. Disconnect BCM and security indicator lamp connector.

3. Check continuity between BCM connector M18 terminal 23 and combination meter type B connector M82 terminal 18 or type A connector M24 terminal 31.

Type B: 23 - 18 : Continuity should exist.

Type A: 23 - 31 : Continuity should exist.

4. Check continuity between BCM connector M18 terminal 23 and ground.

23 - Ground : Continuity should not exist.

Is the inspection result normal?

YES >> Check the following:

  • 10A fuse [No. 8, located in fuse block (J/B)]
  • Harness for open or short between security indicator lamp and fuse

NO >> Repair or replace harness.

SYMPTOM DIAGNOSIS

Power supply and ground circuit

Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS "Wiring Diagram". 1.CHECK FUSES AND FUSIBLE LINK Check that the following fuses and fusible link are not blown. ...

Nissan vehicle immobilizer systemnats symptoms

Symptom Table NOTE: Before performing the diagnosis in the following table, check "SEC "Work Flow"". Check that vehicle is under the condition shown in "Conditions of vehicle" ...

Other materials:

Cleaning interior
Occasionally remove loose dust from the interior trim, plastic parts and seats using a vacuum cleaner or soft bristled brush. Wipe the vinyl and leather surfaces with a clean, soft cloth dampened in mild soap solution, then wipe clean with a dry, soft cloth. Regular care and cleaning is requ ...

Steering gear and linkage
Exploded View 1. Guide 2. Cowl seal 3. Steering gear assembly 4. Front suspension member Front Removal and Installation NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling. REMOVAL Set vehicle to the straight-ahead pos ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0097