Nissan Versa (N17): Nissan vehicle immobilizer systemnats symptoms

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / Nissan vehicle immobilizer systemnats symptoms

Symptom Table

NOTE:

  • Before performing the diagnosis in the following table, check "SEC "Work Flow"".
  • Check that vehicle is under the condition shown in "Conditions of vehicle" before starting diagnosis, and check each symptom.
  • If the following symptoms are detected, check systems shown in the "Diagnosis/service procedure" column in this order.

CONDITIONS OF VEHICLE (OPERATING CONDITIONS)

  • Mechanical key is not inserted into key cylinder.
  • Ignition knob switch is not depressed.                   

REMOVAL AND INSTALLATION

Vehicle security indicator

Description Vehicle security indicator is built in combination meter. NATS (Nissan Anti-Theft System) condition is indicated by blink or illumination of vehicle security indicator. ...

NATS antenna AMP

Removal and Installation NOTE: If NATS antenna amp. is not installed correctly, NVIS (NATS) system will not operate properly and "SELFDIAG RESULTS" on CONSULT screen will show &q ...

Other materials:

Exterior front
1. Engine hood 2. Windshield 3. Wiper and washer switch 4. Power windows (if so equipped) 5. Door locks. NISSAN Intelligent Key (if so equipped). Key fob (if so equipped). Keys 6. Mirrors 7. Tire pressure. Flat tire. Tire chains 8. Headlight and turn signal switch. Replacing bulbs 9. Fo ...

CSC (Concentric slave cylinder)
Exploded View 1. Transaxle assembly 2. CSC (concentric slave cylinder) Removal and Installation CAUTION: Do not reuse CSC (concentric slave cylinder). CSC slides back to the original position every time when removing transaxle assembly. At this time, dust on the sliding parts may ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0067