Exploded View
1. Joint cover 2. Steering gear assembly 3. Inner socket 4. Large clamp 5. Boot 6. Small boot clamp 7. Outer socket
DISASSEMBLY
ASSEMBLY
CAUTION: Do not reuse boot clamps.
Tool number : KV40107300 ( - )
Inner socket length (L) : Refer to ST "Ball Joint Swing Force".
CAUTION: Adjust toe-in after this procedure. The length achieved after toe-in adjustment is not necessarily the above value.
INSPECTION AFTER DISASSEMBLY
Boot
Steering gear Assembly
Outer Socket and Inner Socket
BALL JOINT SWINGING FORCE
Tool number : - (J-44372)
Measuring point of outer socket (1) : Ball stud upper side (A)
Measuring point of inner socket (2) : Point (B)
Swinging force : Refer to ST "Ball Joint Swing Force".
BALL JOINT AXIAL END PLAY
Axial end play : Refer to ST "Ball Joint Axial End Play".
SERVICE DATA AND SPECIFICATIONS (SDS)
General Specifications
Steering Wheel Axial End Play and Play
Steering Wheel Turning Force
Steering Angle
Steering Column Operating Range
*: For measuring position, refer to ST "Inspection".
Rack Stroke
Ball Joint Swing Force
*: For measuring position, refer to ST "Inspection".
Ball Joint Axial End Play
Inner Socket Length
Exploded View 1. Guide 2. Cowl seal 3. Steering gear assembly 4. Front suspension member Front Removal and Installation NOTE: When removing components such as hoses, tubes/lines, etc., cap o ...
Drive belt
1. Water pump pulley
2. Generator pulley
3. Manual tensioner pulley
4. Air conditioner compressor pulley
5. Crankshaft pulley
WARNING
Be sure the ignition switch is placed in the
OFF or LOCK position before servicing
drive belt. The engine could rotate
unexpectedly.
1. Visually inspect t ...
Removal and installation
ECM
Exploded View
1. ECM bracket 2. ECM
: Vehicle front
Removal and Installation
CAUTION: Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refer to
EC-122, "Work Procedure".
REMOVAL
Remove battery. Refer to PG, "Removal and Installation".
Remove IPDM E/R. Re ...