Nissan Versa (N17): Door lock

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Door lock

DOOR LOCK : Removal and Installation

REMOVAL

  1. Remove inside handle. Refer to DLK "INSIDE HANDLE : Removal and Installation".
  2. Remove outside handle. Refer to DLK "OUTSIDE HANDLE : Removal and Installation".
  3. Disconnect the harness connector from door lock actuator (if equipped).
  4. Remove front door lower sash (rear). Refer to GW "Exploded View".
  5. Remove door lock assembly bolts and door lock assembly.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Do not reuse door lock assembly bolt. Always replace it with a new one when it is removed.
  • After installation, check door open/close, lock/unlock operation.
  • Check door lock cable is properly engaged with outside handle bracket.
  • Check door lock assembly for poor lubrication. Apply a suitable multi-purpose grease to door lock if necessary.

INSTALLATION

Inside handle

INSIDE HANDLE : Removal and Installation REMOVAL 1. Remove front door finisher. Refer to INT "Removal and Installation". 2. Remove upper side of sealing screen. NOTE: Cut the butyl ta ...

Other materials:

Continuously Variable Transmission (CVT) fluid (if so equipped)
CAUTION NISSAN recommends using Genuine NISSAN CVT Fluid NS-3 (or equivalent) ONLY in NISSAN CVTs. Do not mix with other fluids. Do not use Automatic transmission fluid (ATF) or Manual transmission fluid in a NISSAN CVT, as it may damage the CVT. Damage caused by the use of fluids ...

Final drive
Exploded View 1. Differential side bearing outer race 2. Differential side bearing 3. Final drive : Replace the parts as a set. Disassembly Remove differential side bearings, using Tool (A) and suitable tool. Tool number : ST33052000 ( - ) Assembly Install differential sid ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0872